Boost control
BoostLogic
Standalone CO2 boost controller with a built-in screen and two fast solenoid drivers.
BoostLogic with its screen, D-pad and harness connector.
What it does
- Drives separate fill and vent solenoids to raise and lower boost.
- Reads boost pressure and throttle position through high-resolution analog inputs, plus tach, vehicle speed, launch and burnout inputs.
- A 2-inch IPS screen and D-pad on the unit itself.
- Bluetooth and Wi-Fi hardware for phone tuning and logging.
- Designed to mount on a standard GoPro mount.
Specifications
| Processor | 32-bit microcontroller with Bluetooth and Wi-Fi |
|---|---|
| Display | 2-inch IPS |
| Solenoid outputs | 2, low-side |
| Analog inputs | High-resolution, 0–5 V |
| Harness connector | Micro-Fit 3.0 style, 14-position |
| PC connection | USB-C |
| Mounting | Standard GoPro mount, through a slide-on dovetail adapter |
Pinout
PowerGroundInputOutput
Harness connector
Micro-Fit 3.0 style, 14-position. Rows as they sit on the board.
- 1Sensor 5 V
- 2Solenoid 2, vent
- 3Solenoid 1, fill
- 412 V solenoid feed
- 5Ground
- 6Ground
- 7Battery in
- 8Launch switch
- 9Burnout switch
- 10Vehicle speed
- 11Tach
- 12Sensor ground
- 13Throttle position
- 14Boost pressure
Not to scale. Check the numbers molded on the connector before wiring. Pin colors only show each pin's function. They don't reflect the actual wire colors of any included pigtail.
Before you buy
- Solenoids connect between pin 4 and pins 2 and 3, which switch to ground.
- The harness plug is a standard Micro-Fit 43025-1400 housing.